Sure, here you go.
So, to explain the Sample Curve, a comfortable postion to hold the device is at Vector X -0.50 (landscape left). So I have a range of -0.60 to -0.40 which means I only rotate the device very slightly to change from -0.60 to -0.40.
(Note to Jean or Alex, would be great if we could type these numbers in, very fiddly
)
And then I just want my camera to rotate to min -25 degrees, to max 25 degrees. So graph coords are -0.60, -25 to 0.40, 25.
And then do the same thing for the left and right. I just output the Get device accel vectors and round them and note down the rangle I need (in my case -0.8 to 0.
.
Calibration shouldn't be a problem but would be a lot easier if you could type in vector 2 variables into the Sample Curve action so they could be dynamic.
Mark